I have a 2532A working w/ 3.14 and a MVME 2700. They look pretty
similar. The support was modified from a version that worked w/ an
mvme162 and 3.13. I think the original author was George Lahti.
dale b.
Laznovsky, Michael wrote:
Hi- does anyone out there have EPICS 3.14 support for the VMIC 2534 module? The EPICS
website shows only a 3.13 version.
Found 3.14 support for VMIC 3122/4132 here: http://www.fel.duke.edu/epics/downloads/
(but haven't tried them yet).
thanks,
Mike
--
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
Dale L. Brewe
PNC/XOR Argonne National Laboratory
ph: 630 252 0582 fax: 630 252 0580
Mail:
Argonne National Laboratory
Bldg 435E sector 20
9700 S. Cass Ave.
Argonne, IL 60439
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
- References:
- Is there any chance that I can change SCAN parameter dynamically? Zhichu Chen
- Re: Is there any chance that I can change SCAN parameter dynamically? Ned Arnold
- Re: Is there any chance that I can change SCAN parameter dynamically? Maren Purves
- VMIC 2534 3.14 support? Laznovsky, Michael
- Navigate by Date:
- Prev:
VMIC 2534 3.14 support? Laznovsky, Michael
- Next:
Re: Is there any chance that I can change SCAN parameter dynamically? Emmanuel Mayssat
- Index:
1994
1995
1996
1997
1998
1999
2000
2001
2002
2003
2004
2005
2006
<2007>
2008
2009
2010
2011
2012
2013
2014
2015
2016
2017
2018
2019
2020
2021
2022
2023
2024
- Navigate by Thread:
- Prev:
VMIC 2534 3.14 support? Laznovsky, Michael
- Next:
Re: VMIC 2534 3.14 support? Steven Hartman
- Index:
1994
1995
1996
1997
1998
1999
2000
2001
2002
2003
2004
2005
2006
<2007>
2008
2009
2010
2011
2012
2013
2014
2015
2016
2017
2018
2019
2020
2021
2022
2023
2024
|