Experimental Physics and
Industrial Control System

Hi- does anyone out there have EPICS 3.14 support for the VMIC 2534 module?  The EPICS 
website shows only a 3.13 version.

Found 3.14 support for VMIC 3122/4132 here: http://www.fel.duke.edu/epics/downloads/ 
(but haven't tried them yet).

thanks,
Mike

Replies:

Re: VMIC 2534 3.14 support? Dale L. Brewe

Re: VMIC 2534 3.14 support? Steven Hartman

References:

Is there any chance that I can change SCAN parameter dynamically? Zhichu Chen

Re: Is there any chance that I can change SCAN parameter dynamically? Ned Arnold

Re: Is there any chance that I can change SCAN parameter dynamically? Maren Purves

Navigate by Date:

Prev: Re: Is there any chance that I can change SCAN parameter dynamically? Maren Purves

Next: Re: VMIC 2534 3.14 support? Dale L. Brewe

Index: 1994  1995  1996  1997  1998  1999  2000  2001  2002  2003  2004  2005  2006  <2007>  2008  2009  2010  2011  2012  2013  2014  2015  2016  2017  2018  2019  2020  2021  2022  2023  2024 

Navigate by Thread:

Prev: Re: Is there any chance that I can change SCAN parameter dynamically? Maren Purves

Next: Re: VMIC 2534 3.14 support? Dale L. Brewe

Index: 1994  1995  1996  1997  1998  1999  2000  2001  2002  2003  2004  2005  2006  <2007>  2008  2009  2010  2011  2012  2013  2014  2015  2016  2017  2018  2019  2020  2021  2022  2023  2024