Experimental Physics and
Industrial Control System

"wtw00992" <[email protected]> · Fri, 17 Sep 2004 00:10:26 -0400

Greetings (from sleepless in L.I.)
I am trying to use a TIP-810 with a Xycom 9660. I followed the instructions
from Andy Fosters site at OSL..
Things looked ok when I did my make but the processor hung up at
intitialization..
I didnt copy all of the files drvIpac.dbd files and header files from the
xycom-1.0 dir over to drvIpac, as they seem to be older versions that what
I have in my drvIpac <support top>, I did a diff and didnt see any
differences in the .dbd, but saw some in one of the header files...
I was wondering if there was an update to the xycom 9660 files.. or perhaps
a better way to do this.. by making a completely separate <support top> for
the xycom.

I am presupposing that some body out there has used the TIP810 with this
board... one of our subsytems purchased it and I would like to get it to
work, eventually with both a TIP 810 and an IP-OCTAL 232.. but certainly
with the TIP 810.

Thanks in advance for your comments.

Bill Waggoner

STAR

BNL/Upton NY

or

Creighton Univ/Omaha NE 

Experimental Physics and Industrial Control System

Experimental Physics and
Industrial Control System