Experimental Physics and
Industrial Control System

On 9/6/2012 5:51 PM, Allison, Stephanie wrote:

Hi Michael,

Does it make sense to add epicsDma to devLib2 or should it be in another module?  epicsDma comes from the GTR (generic transient recorder, aka, digitizer) module.  Till provided SLAC with an RTEMS layer under epicsDma to supplement the vxWorks implementation.  Eric Norum would have give permission to move epicsDma from GTR to devlib2.   GTR would then require devlib2 to build.

I wouldn't have a problem with this.

References:

Epics driver using BLT or CBLT to read FIFO wanted Bai Jiaoni

Re: Epics driver using BLT or CBLT to read FIFO wanted Till Straumann

RE: Epics driver using BLT or CBLT to read FIFO wanted Mark Rivers

Re: Epics driver using BLT or CBLT to read FIFO wanted Benjamin Franksen

RE: Epics driver using BLT or CBLT to read FIFO wanted Davidsaver, Michael

RE: Epics driver using BLT or CBLT to read FIFO wanted Allison, Stephanie

Navigate by Date:

Prev: Re: Epics driver using BLT or CBLT to read FIFO wanted Michael Davidsaver

Next: Re: EPICS build system, RELEASE file, and relative paths Angus Gratton

Index: 1994  1995  1996  1997  1998  1999  2000  2001  2002  2003  2004  2005  2006  2007  2008  2009  2010  2011  <2012>  2013  2014  2015  2016  2017  2018  2019  2020  2021  2022  2023  2024 

Navigate by Thread:

Prev: RE: Epics driver using BLT or CBLT to read FIFO wanted Allison, Stephanie

Next: RE: Epics driver using BLT or CBLT to read FIFO wanted Mark Rivers

Index: 1994  1995  1996  1997  1998  1999  2000  2001  2002  2003  2004  2005  2006  2007  2008  2009  2010  2011  <2012>  2013  2014  2015  2016  2017  2018  2019  2020  2021  2022  2023  2024