Experimental Physics and
Industrial Control System

We have been using MAXv boards in place of OMS58 boards for all new
purchases at APS sector 13 and NSLS X-17.  They are basically completely
compatible with the OMS58 for stepper applications.  The nice thing is
that they can be used for DC motors with encoders on a motor-by-motor
basis, and we have used them a bit for DC motor applications.

Mark
  

> -----Original Message-----
> From: Martin Heiniger [mailto:[email protected]] 
> Sent: Wednesday, August 23, 2006 9:33 AM
> To: TECHTALK
> Subject: MAXv Multi-Axis Motion Controller in use?
> 
> Dear all
> 
> do you have a "MAXv Multi-Axis Motion Controller"* from 
> Pro-Dex (OMS) in 
> use? What is your experience?
> 
> I have seen the 2 entries from Ronald L. Sluiter and Jens Eden in the 
> Tech-Talk archive.
> 
> Thanks for any feedback and best regards,
> Martin
> 
> *) http://www.omsmotion.com/product_detail.php?prodid=8
> 
> -- 
> Paul Scherrer Institut (PSI)   Telefon:  +41 (0)56 310 25 66
> HW Controls Group              Telefax:  +41 (0)56 310 44 13
> 5232 Villigen PSI              Postfach: WSLA/210
> SCHWEIZ / SWITZERLAND          Internet: http://www.psi.ch
> 
> 

Navigate by Date:

Prev: Re: Any EPICS support for ICS 145? Ernest L. Williams Jr.

Next: Re: MAXv Multi-Axis Motion Controller in use? Jens Eden

Index: 1994  1995  1996  1997  1998  1999  2000  2001  2002  2003  2004  2005  <2006>  2007  2008  2009  2010  2011  2012  2013  2014  2015  2016  2017  2018  2019  2020  2021  2022  2023  2024 

Navigate by Thread:

Prev: Re: MAXv Multi-Axis Motion Controller in use? Jens Eden

Next: Any EPICS support for ICS 145? Steve Lewis

Index: 1994  1995  1996  1997  1998  1999  2000  2001  2002  2003  2004  2005  <2006>  2007  2008  2009  2010  2011  2012  2013  2014  2015  2016  2017  2018  2019  2020  2021  2022  2023  2024