That should work, although I think the field is SDIS and not DISA.
Thank you,
Iain.
> -----Original Message-----
> From: Mark Rivers [mailto:[email protected]]
> Sent: Monday, May 22, 2017 11:32 AM
> To: Iain Marcuson <[email protected]>
> Subject: Re: Disabling a record from scanning during a program event
>
> I think you could have the query record set it's DISA field to point to the
> detector Acquire PV and the DISV value be 0. That way the record will stop
> scanning when Acquire goes back to 0.
> Mark
>
>
> Sent from my iPhone
>
> > On May 22, 2017, at 11:27 AM, Iain Marcuson
> <[email protected]> wrote:
> >
> > I have a setup that acquires an image from custom AreaDetector code for a
> custom camera. The controller provides a command that returns the
> progress of an acquisition, since they can be quite long. I have created a PV
> to query the progress of the acquisition, querying every 0.2 seconds. I only
> want to scan when an acquisition is in progress. I assume I would
> appropriately set the DISV and DISA fields of the progress PV. However, I am
> lost at how I would set these variables from the acquisition code. Is there an
> example or description of the bindings?
> >
> > Thank you,
> >
> > Iain.
- References:
- Disabling a record from scanning during a program event Iain Marcuson
- Navigate by Date:
- Prev:
RE: Disabling a record from scanning during a program event Iain Marcuson
- Next:
Re: Disabling a record from scanning during a program event Johnson, Andrew N.
- Index:
1994
1995
1996
1997
1998
1999
2000
2001
2002
2003
2004
2005
2006
2007
2008
2009
2010
2011
2012
2013
2014
2015
2016
<2017>
2018
2019
2020
2021
2022
2023
2024
- Navigate by Thread:
- Prev:
Re: Disabling a record from scanning during a program event Johnson, Andrew N.
- Next:
Force TCP/IP reconnect from Asyn/Streamdevice Christoph Schroeder
- Index:
1994
1995
1996
1997
1998
1999
2000
2001
2002
2003
2004
2005
2006
2007
2008
2009
2010
2011
2012
2013
2014
2015
2016
<2017>
2018
2019
2020
2021
2022
2023
2024
|