Experimental Physics and
Industrial Control System

"Hu, Yong" <[email protected]> · Tue, 7 Sep 2010 10:57:37 -0400

Hello Leige,

We're using cPCI products at NSLS-2 diagnostics controls system for DAQ
applications. 
1. CPU board: Agilent U1091AK11(Acqiris PP410, Intel Core Duo
Processor), Debian/Linux OS; 
2. Crate: Agilent Acqiris U1091AC50, 5-slot;
3. high-speed digitizer: Agilent U1065A-002(DC252), 2-channel, 4~8GS/s,
10-bit, 7-bit ENOB;
4. high-resolution digitizer(just purchased): GE ICS-710A-8, 8-Channel,
200KS/s, 24-Bit;
The high-speed digitizer is used for filling pattern measurements(wall
current monitor, Bergoz FCT, etc) and the high-resolution digitizer for
Bergoz DCCT. 

All these cPCI-based DAQ systems are/will be running with EPICS/Linux.

Yong

-----Original Message-----
From: [email protected]
[mailto:[email protected]] On Behalf Of leige
Sent: Tuesday, September 07, 2010 10:09 AM
To: [email protected]
Subject: cPCI

Dear all,

I'am seeking comments and suggestions on cPCI. Do (or did) you use cPCI
as the EPICS IOC? Could you tell me the module name, manufacture, and
operating system you select for it? A hardware group in our project
prefers to use cPCI to construct their low levle controls and ask if it
can be ported to EPICS. I searched tech-talk but the clues are only a
few. So please give me some comments on this.

Thank you very much,

Ge

Experimental Physics and Industrial Control System

Experimental Physics and
Industrial Control System