Experimental Physics and
Industrial Control System

Wesley Moore <[email protected]> · Wed, 20 Jan 2010 12:18:02 -0500

The other cards like this on other IOCs have always been set to 0x0000
(the jumpers match that also). The card did initialize yesterday after
I seemingly did nothing different. I think I've screwed up something to
do with ipac but it all seems fine. That's why I'm confused.
Wesley

Mark Rivers wrote:

You are telling it that your VIPC616 is set up for A16 address 0x0000.
Is this correct?  I've always put my cards at higher addresses than
this.
Mark

-----Original Message-----
From: [email protected]
[mailto:[email protected]] On Behalf Of [email protected]
Sent: Wednesday, January 20, 2010 10:54 AM
To: [email protected]
Subject: Ipac with VIPC616
Hey All,
I'm trying to setup a SBS VIPC616 with one IP-OCTAL-232 IP-pack.  The
jumper settings on the carrier have been checked and are correct.  After
issuing ipacAddVIPC616, the module is still not found.  Here's what I
see
on the IOC:
vxwrks@iocfel7 -> ipacAddVIPC616("0x0000,0x0A000000")
value = 0 = 0x0
vxwrks@iocfel7 -> ipacReport(2)
    IP Carrier  0: SBS/GreenSpring VIPC616, 4 slots
      C0 S0 : No Module
        ID = 0xfbff0080, I/O = 0xfbff0000, Mem = 0x12000000
      C0 S1 : No Module
        ID = 0xfbff0180, I/O = 0xfbff0100, Mem = 0x12800000
      C0 S2 : No Module
        ID = 0xfbff0280, I/O = 0xfbff0200, Mem = 0x13000000
      C0 S3 : No Module
        ID = 0xfbff0380, I/O = 0xfbff0300, Mem = 0x13800000
value = 0 = 0x0
I've tried this with Ipac and Asyn version already installed here at
Jlab
and have setup my own using ipac-2.8 and asyn-4.11.  Any ideas on why
the
module is not being initialized?
Wesley

begin:vcard
fn:Wesley Moore
n:Moore;Wesley
org:Thomas Jefferson National Accelerator Facility;Free Electron Laser
adr:Suite 19, MS 18;;12000 Jefferson Avenue;Newport News;VA;23606;USA
email;internet:[email protected]
title:FEL Computer Scientist
tel;work:(757) 269-6033
tel;fax:(757) 269-6384
tel;pager:(757) 584-6033
url:http://www.jlab.org/FEL/
version:2.1
end:vcard

Experimental Physics and Industrial Control System

Experimental Physics and
Industrial Control System