Experimental Physics and
Industrial Control System

You are telling it that your VIPC616 is set up for A16 address 0x0000.
Is this correct?  I've always put my cards at higher addresses than
this.

Mark


-----Original Message-----
From: [email protected]
[mailto:[email protected]] On Behalf Of [email protected]
Sent: Wednesday, January 20, 2010 10:54 AM
To: [email protected]
Subject: Ipac with VIPC616

Hey All,

I'm trying to setup a SBS VIPC616 with one IP-OCTAL-232 IP-pack.  The
jumper settings on the carrier have been checked and are correct.  After
issuing ipacAddVIPC616, the module is still not found.  Here's what I
see
on the IOC:

vxwrks@iocfel7 -> ipacAddVIPC616("0x0000,0x0A000000")
value = 0 = 0x0
vxwrks@iocfel7 -> ipacReport(2)
    IP Carrier  0: SBS/GreenSpring VIPC616, 4 slots
      C0 S0 : No Module
        ID = 0xfbff0080, I/O = 0xfbff0000, Mem = 0x12000000
      C0 S1 : No Module
        ID = 0xfbff0180, I/O = 0xfbff0100, Mem = 0x12800000
      C0 S2 : No Module
        ID = 0xfbff0280, I/O = 0xfbff0200, Mem = 0x13000000
      C0 S3 : No Module
        ID = 0xfbff0380, I/O = 0xfbff0300, Mem = 0x13800000
value = 0 = 0x0

I've tried this with Ipac and Asyn version already installed here at
Jlab
and have setup my own using ipac-2.8 and asyn-4.11.  Any ideas on why
the
module is not being initialized?

Wesley

Replies:

Re: Ipac with VIPC616 Wesley Moore

References:

Ipac with VIPC616 wmoore

Navigate by Date:

Prev: Ipac with VIPC616 wmoore

Next: Re: Ipac with VIPC616 Wesley Moore

Index: 1994  1995  1996  1997  1998  1999  2000  2001  2002  2003  2004  2005  2006  2007  2008  2009  <2010>  2011  2012  2013  2014  2015  2016  2017  2018  2019  2020  2021  2022  2023  2024 

Navigate by Thread:

Prev: Ipac with VIPC616 wmoore

Next: Re: Ipac with VIPC616 Wesley Moore

Index: 1994  1995  1996  1997  1998  1999  2000  2001  2002  2003  2004  2005  2006  2007  2008  2009  <2010>  2011  2012  2013  2014  2015  2016  2017  2018  2019  2020  2021  2022  2023  2024