Experimental Physics and
Industrial Control System

Mauro Giacchini <[email protected]> · Thu, 02 Aug 2007 11:32:26 +0200

In the EPICS wiki-pages there is a document which may give you someone
hints:
http://www.aps.anl.gov/epics/wiki/index.php/HowToPC104
Hope this helps
Mauro.
David DeBonis wrote:

We are working on an embedded EPICS IOC deployment but are running
into some confusion on what is necessary to build to our target
architecture which is ARM running a linux kernel 2.6.x. We have our
own cross-compilers that we would like to use and build with but we
seem to be running into issue with some post-build executables that
need to be run on the target.

Can someone clarify what EPICS binaries are necessary to be deployed
to the target to run as a "Soft IOC" standalone? Also, can we
cross-compile all we need on our host system yet run fully standalone
on the target?

Just to be clear, we are not running as a slave target to a host
computer but as a fully standalone embedded host IOC.

Any clarification is deeply appreciated.

*David DeBonis*

Principal Software Engineer

ZTEC Instruments, Inc.

Phone: 505-342-0132 x133

Fax: 505-342-0222

[email protected] <mailto:[email protected]>

--

~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~

Mauro Giacchini

Istituto Nazionale di Fisica Nucleare - Laboratori Nazionali di Legnaro

V.le dell?Universita', 2

35020 LEGNARO (PD) ? ITALY

Tel. +39.049.8068558

Fax. +39.049.641925

EPICS official distribution: LivEPICS
http://www.aps.anl.gov/epics/distributions/index.php

EPICS@LNL : http://www.lnl.infn.it/~epics/

~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~

Experimental Physics and Industrial Control System

Experimental Physics and
Industrial Control System