Experimental Physics and
Industrial Control System

The correct link is:
http://www.nsls.bnl.gov/facility/expsys/software/
Pete.

We have Modbus / TCP device support running under VxWorks:

http://isacwserv.triumf.ca/epics/modtcp/TRIUMFmodtcp.html

I think NSLS ported this to WAGO PLCs on Linux, but the link I had is broken.

- rolf -

Mark Rivers wrote:

Folks,

I want to communicate from an EPICS IOC (cygwin32) to a DL205 PLC system
from AutomationDirect.  I want to use Ehternet with the H2-ECOM100
module.  This module supports MODBUS.

Is there EPICS support for this? Where is the best place to get it?

Thanks,

Mark Rivers

--
D. Peter Siddons
Detector Development Group leader,
National Synchrotron Light Source
Brookhaven National Laboratory
Upton, NY 11973

email: [email protected]
Phone: (631) 344-2738

References:

MODBUS communication with H2-ECOM100 AuotmationDirect DL205 system? Mark Rivers

Re: MODBUS communication with H2-ECOM100 AuotmationDirect DL205 system? Rolf Keitel

Navigate by Date:

Prev: Re: evaluation of OMG DDS as a controls protocol for EPICS Claude Saunders

Next: time synchronization Geoff Savage

Index: 1994  1995  1996  1997  1998  1999  2000  2001  2002  2003  2004  2005  2006  <2007>  2008  2009  2010  2011  2012  2013  2014  2015  2016  2017  2018  2019  2020  2021  2022  2023  2024 

Navigate by Thread:

Prev: Re: MODBUS communication with H2-ECOM100 AuotmationDirect DL205 system? Rolf Keitel

Next: RE: MODBUS communication with H2-ECOM100 AuotmationDirect DL205 system? Mark Rivers

Index: 1994  1995  1996  1997  1998  1999  2000  2001  2002  2003  2004  2005  2006  <2007>  2008  2009  2010  2011  2012  2013  2014  2015  2016  2017  2018  2019  2020  2021  2022  2023  2024