Experimental Physics and
Industrial Control System

I am looking for multi-channel CAMAC-based stepper motor controllers
that have EPICS device support available and are still being
manufactured. Anything out there besides the DSP E500?

Best regards,
    Peregrine
--
Dr. Peregrine M. McGehee	
Los Alamos Neutron Science Center
MS H820         Los Alamos National Laboratory
(505) 667-3273  Los Alamos, NM 87545

Replies:

RE: CAMAC-based stepper motor controllers Darrell Nineham

Navigate by Date:

Prev: Re: Writing to PVs Kay-Uwe Kasemir

Next: RE: CAMAC-based stepper motor controllers Darrell Nineham

Index: 1994  1995  1996  1997  1998  1999  2000  2001  2002  2003  2004  <2005>  2006  2007  2008  2009  2010  2011  2012  2013  2014  2015  2016  2017  2018  2019  2020  2021  2022  2023  2024 

Navigate by Thread:

Prev: Re: CA information on IOC? Ralph Lange

Next: RE: CAMAC-based stepper motor controllers Darrell Nineham

Index: 1994  1995  1996  1997  1998  1999  2000  2001  2002  2003  2004  <2005>  2006  2007  2008  2009  2010  2011  2012  2013  2014  2015  2016  2017  2018  2019  2020  2021  2022  2023  2024