Experimental Physics and
Industrial Control System

"Darrell Nineham" <[email protected]> · Tue, 22 Nov 2005 08:56:44 -0000

Yes there is, Hytec produce 2404 

It is in use at Brookhaven. They have been using them for a few years; I
don't know if they have EPICS support (anyone out there in tech-talk
land know the answer ?). The E500 has not been produced for some years
and our 2404 was adopted at BNL to replace exactly that unit.

Darrell Nineham
Hytec Electronics Ltd.
Tel: +44 (0) 118 975 7770
Fax: +44 (0) 118 975 7566
Web: www.hytec-electronics.co.uk

++++++++++++++++++++++++++++++++++++++++++++
This email and any files transmitted with it are confidential and
intended solely for the use of the individual or entity to whom they are
addressed. If you have received this email in error, please notify the
sender immediately. The views expressed in the message are those of the
individual author and may not necessarily represent the views of Hytec
Electronics Ltd.

-----Original Message-----
From: Peregrine M. McGehee [mailto:[email protected]] 
Sent: 21 November 2005 16:18
To: [email protected]
Subject: CAMAC-based stepper motor controllers

I am looking for multi-channel CAMAC-based stepper motor controllers
that have EPICS device support available and are still being
manufactured. Anything out there besides the DSP E500?

Best regards,
     Peregrine
-- 
Dr. Peregrine M. McGehee	
Los Alamos Neutron Science Center
MS H820         Los Alamos National Laboratory
(505) 667-3273  Los Alamos, NM 87545

Experimental Physics and Industrial Control System

Experimental Physics and
Industrial Control System