Experimental Physics and
Industrial Control System

Geoff Savage <[email protected]> · Mon, 06 Dec 2004 14:44:09 -0600

Hi,
We have just finished upgrading about 75% of the control system nodes to
EPICS 3.14.6/vxworks 5.5. The remaining nodes are running EPICS 3.13.4
with some patches/vxworks 5.3.1. We have noticed more channel access
errors with the later version of epics in the system than with an all
EPICS 3.13.4 system. Is this to be expected at this time? Will the
EPICS 3.14.7 release remove the errors? I understand that I don't have
any details but the situatuions encountered are not reporduceable and
everyone can get their work done. Over the past week while we have
installed the new software we have been fielding questions about error
messages appearing that have not been seen before.
Geoff

Experimental Physics and Industrial Control System

Experimental Physics and
Industrial Control System