Experimental Physics and
Industrial Control System

Ditto on the wish list from BESSRC as well . . .

I'm been told that the NI-1014 board is supported, but the jumper settings
are not what the board comes as or used with NiDAQ type software. Someone
told me what the settings should be to run under EPICS but I could never
get the thing to recognize correctly.

Wonder if there is a book market for someone to write "EPICS for Idiots"?

Me


----------
> From: Ernest L. Williams Jr. <[email protected]>
> 
> I am one of the APS beam line users responsible for beamline controls.   
I am in the market for a nice GPIB
> RS232/RS485 VME-based solution running under EPICS only.
> 
> For my application HIDEOS is too much overhead.  I think HIDEOS is an
excellent system but its use, of course,
> is application dependent.
> 
> 
> Is anyone using the GPIB 1014 by National Instruments under EPICS?  
> 

Navigate by Date:

Prev: Serial and GPIB IP's and IP Carriers Ernest L. Williams Jr.

Next: Re: Serial and GPIB IP's and IP Carriers S. Joshua Stein

Index: 1994  1995  <1996>  1997  1998  1999  2000  2001  2002  2003  2004  2005  2006  2007  2008  2009  2010  2011  2012  2013  2014  2015  2016  2017  2018  2019  2020  2021  2022  2023  2024 

Navigate by Thread:

Prev: Serial and GPIB IP's and IP Carriers Ernest L. Williams Jr.

Next: Re: Serial and GPIB IP's and IP Carriers S. Joshua Stein

Index: 1994  1995  <1996>  1997  1998  1999  2000  2001  2002  2003  2004  2005  2006  2007  2008  2009  2010  2011  2012  2013  2014  2015  2016  2017  2018  2019  2020  2021  2022  2023  2024