Experimental Physics and
Industrial Control System

The last problem reports smelled as if the code executed was not corresponding
to the source code. (things not compiled/linked appropriately)

This one looks the same.
Can you put your source code somewhere ?




On 17/10/17 11:07, Jörn Dreyer wrote:

Hi,

still fighting with the motor record...

I get a strange error message at startup of my IOC:

asynPortDriver:setDoubleParam: port=port1 error setting parameter 19 in list
0, wrong type
asynMotorController:writeFloat64 error, status=8 axis=0, function=19,
value=0.000000
devMotorAsyn::asynCallback: m1 pasyn{Float64,Int32}->write returned <empty
error message>

In my parameter list the number 19 is motorClosedLoop, which indeed is an
int32 parameter. I'm using basic_asyn_motor.db to setup the motor record.

What goes wrong here?

Regards

Jörn

Replies:

Re: Problems with motor record Jörn Dreyer

References:

Problems with motor record Jörn Dreyer

Navigate by Date:

Prev: Problems with motor record Jörn Dreyer

Next: Re: Problems with motor record Jörn Dreyer

Index: 1994  1995  1996  1997  1998  1999  2000  2001  2002  2003  2004  2005  2006  2007  2008  2009  2010  2011  2012  2013  2014  2015  2016  <2017>  2018  2019  2020  2021  2022  2023  2024 

Navigate by Thread:

Prev: Problems with motor record Jörn Dreyer

Next: Re: Problems with motor record Jörn Dreyer

Index: 1994  1995  1996  1997  1998  1999  2000  2001  2002  2003  2004  2005  2006  2007  2008  2009  2010  2011  2012  2013  2014  2015  2016  <2017>  2018  2019  2020  2021  2022  2023  2024