Experimental Physics and Industrial Control System
Hi
I am experimenting with EPICS IOC Redundancy, the redundancy code(rmt and cce) has been compiled, and two systems have been configured as Master and Slave.
However, i guess there is an issue with the configuration as when i run the command "rmtState" to check the status of these Systems, i get
the following output on both systems(Master and Slave):
RMT Local State=Master Remote State=Unknown
Public Eth (socket=0 down), Private Eth (socket=0 down), Global Eth (down)
Local drv (running=0 failed=0)
Remore drv are not in sync
Can anyone put some light on the issue and any possible solutions?
Any help in this regard is highly appreciated.
Best Regards
M.S
- Replies:
- RE: EPICS IOC Redundancy Configuration Baily, Scott A
- Navigate by Date:
- Prev:
Re: Writing PVs from an amalgamated structure Ralph Lange
- Next:
EPICS areadetecto and EPICSV4 Jörn Dreyer
- Index:
1994
1995
1996
1997
1998
1999
2000
2001
2002
2003
2004
2005
2006
2007
2008
2009
2010
2011
2012
2013
2014
2015
2016
<2017>
2018
2019
2020
2021
2022
2023
2024
- Navigate by Thread:
- Prev:
Re: mrfioc2 release 2.2.0 Jeong Han Lee
- Next:
RE: EPICS IOC Redundancy Configuration Baily, Scott A
- Index:
1994
1995
1996
1997
1998
1999
2000
2001
2002
2003
2004
2005
2006
2007
2008
2009
2010
2011
2012
2013
2014
2015
2016
<2017>
2018
2019
2020
2021
2022
2023
2024