Thanks very much for the quick reply. And especially for the example code!
> On Sep 26, 2017, at 8:27 AM, Goetze, Kurt A. <[email protected]> wrote:
>
> Hi Eric,
>
> According to PI, this controller uses the "PI General Command Set" (GCS). So motorApp/PIGCS2Src should work. PI wrote this driver, so they should be able to help you if you if this code needs to be updated. They have been helpful in the past. Our contact at PI is Steffen Rau.
> On Sep 26, 2017, at 8:27 AM, Roehrig, Christian <[email protected]> wrote:
>
> Hi Eric,
>
> I am using these stages with driver from the PIGCS2Src directory in the motor module. Here are the contents of the file I load at boot time.
>
--
Eric Norum
[email protected]
- References:
- PI E-873 motors Eric Norum
- Re: PI E-873 motors Roehrig, Christian
- Navigate by Date:
- Prev:
RE: PI E-873 motors Goetze, Kurt A.
- Next:
Re: EPICS base startup directory in an installation location. Andrew Johnson
- Index:
1994
1995
1996
1997
1998
1999
2000
2001
2002
2003
2004
2005
2006
2007
2008
2009
2010
2011
2012
2013
2014
2015
2016
<2017>
2018
2019
2020
2021
2022
2023
2024
- Navigate by Thread:
- Prev:
Re: PI E-873 motors Roehrig, Christian
- Next:
RE: PI E-873 motors Goetze, Kurt A.
- Index:
1994
1995
1996
1997
1998
1999
2000
2001
2002
2003
2004
2005
2006
2007
2008
2009
2010
2011
2012
2013
2014
2015
2016
<2017>
2018
2019
2020
2021
2022
2023
2024
|