Folks,
Release 1-4 of the measComp module is now available.
This is from the release notes:
********************************
- Added support to drvMultiFunction for the USB-1608G.
This is similar to the previously supported USB-1608GX-2A0 except that it is 250 kHz vs 500 kHz, and does not have the 2 analog output ports.
- Added support for new version of USB-1608GX-2A0 which is functionally the same but has a different board type identifier.
- Renamed the iocBoot/iocUSB1608G to iocUSB1608G-2A0, and added new iocUSB1608 directory for the USB-1608G.
- Added support to drvMultiFunction for the USB-231, and a new iocUSB231 directory.
- Removed parameter counting and NUM_PARAMS argument to asynPortDriver constructor in all drivers. These are not needed in asyn R4-32.
********************************
The home page for measComp is here:
http://cars.uchicago.edu/software/epics/measComp.html
The documentation is here:
http://cars.uchicago.edu/software/epics/measCompDoc.html
The release notes are here:
http://cars.uchicago.edu/software/epics/measCompReleaseNotes.html
The source repository is on Github:
https://github.com/epics-modules/measComp
Cheers,
Mark