Hi

I am running the acctst (r3.14.12.5) on a softIOC (REHLv7).

acctst timerperiod 2 1 10 1

where timerperiod is an analog output record with DTYP of Soft Channel

 

Everything runs fine up until the caTaskExitTest (see below).

Any ideas as to why ca_task_exit() would cause a segmentation fault.

Thx,

Al

 

.

.

.

verifyAnalogIO {} 0.019500 sec

verifyAnalogIO {} 0.017648 sec

multiSubscriptionDeleteTest {...} 0.080886 sec

singleSubscriptionDeleteTest {..........} 0.842084 sec

channelClearWithEventTrafficTest {} 27.055007 sec

monitorUpdateTest {...} 1.107345 sec

verifyHighThroughputRead {} 0.003613 sec

verifyHighThroughputWrite {} 0.000780 sec

verifyHighThroughputReadCallback {} 0.101164 sec

verifyHighThroughputWriteCallback {} 0.101897 sec

verifyBadString {Test fails if stim "8" isnt roughly equiv to resp "8.000000"

} 0.000064 sec

verifyMultithreadSubscr {.} 0.097351 sec

 

CA pend event delay = 1.000000 sec results in error = 0.012294 %

CA pend event delay = 0.100000 sec results in error = 0.111641 %

CA pend event delay = 0.250000 sec results in error = 0.051082 %

ca_client_context at 0xf0bcd0 pndRecvCnt=0 ioSeqNo=4371

verifyConnectionHandlerConnect {........................................} 1.002006 sec

verifyBlockingConnect {........................................} 0.370005 sec

verifyClear {} 0.000008 sec

verifyReasonableBeaconPeriod {Beacon anomalies detected since program start 7

Estimated beacon period for channel ss1:om1s:timerperiod = -1.79769e+308 sec.

busy: receive watchdog for "ss1:om1s:timerperiod" expires in 29.9219 sec.

...............

inactive: receive watchdog for "ss1:om1s:timerperiod" expires in 29.9887 sec.

} 30.001885 sec

caTaskExitTest {Segmentation fault (core dumped)