EPICS Home

Experimental Physics and Industrial Control System


 
1994  1995  1996  1997  1998  1999  2000  2001  2002  2003  2004  2005  2006  2007  2008  2009  2010  2011  2012  2013  2014  2015  2016  <20172018  2019  2020  2021  2022  2023  2024  Index 1994  1995  1996  1997  1998  1999  2000  2001  2002  2003  2004  2005  2006  2007  2008  2009  2010  2011  2012  2013  2014  2015  2016  <20172018  2019  2020  2021  2022  2023  2024 
<== Date ==> <== Thread ==>

Subject: MEDM 3.1.11 link
From: Jiro Fujita <[email protected]>
To: Epics <[email protected]>
Date: Tue, 18 Jul 2017 11:02:19 +0200
Hello, 

Not a huge problem, but it appears the MEDM 3.1.11 download link on the EPICS MEDM page is wrong.  

http://www.aps.anl.gov/epics/extensions/medm/index.php

I realized when I was configuring MEDM.  I thought I downloaded MEDM 3.1.11, but what I got was MEDM 3.1.10 instead.  I checked the link, and the MEDM 3.1.11 and 3.1.10 are both pointed to the same source.  It appears the correct one is the following for MEDM 3.1.11 (it wasn’t very hard to figure out): 




Replies:
Re: MEDM 3.1.11 link Bob Soliday
Re: MEDM 3.1.11 link Andrew Johnson

Navigate by Date:
Prev: GeniCam support for CamLink cameras Bruce Hill
Next: EPICS Workshop at ICALEPCS, Oct 7th, 2017 David Fernández
Index: 1994  1995  1996  1997  1998  1999  2000  2001  2002  2003  2004  2005  2006  2007  2008  2009  2010  2011  2012  2013  2014  2015  2016  <20172018  2019  2020  2021  2022  2023  2024 
Navigate by Thread:
Prev: RE: GeniCam support for CamLink cameras Mark Rivers
Next: Re: MEDM 3.1.11 link Bob Soliday
Index: 1994  1995  1996  1997  1998  1999  2000  2001  2002  2003  2004  2005  2006  2007  2008  2009  2010  2011  2012  2013  2014  2015  2016  <20172018  2019  2020  2021  2022  2023  2024