Experimental Physics and Industrial Control System
> I suspect the problem could be that you used the wrong
> $(P)$(R)ArrayCallbacks record. That must be set using the $(R) for the
> detector driver (perhaps it is cam1:), while $(P)$(R)EnableCallbacks must be
> set for the $(R) of the NDPluginStdArrays plugin (perhaps image1:). The
> former tells your driver to do callbacks to plugins (and controls the
> if(arrayCallbacks) you said was false. The latter controls whether the
> NDPluginStdArrays plugin subscribes to callbacks from the driver.
>
> If you set $(P)$(R)ArrayCallbacks for the NDPluginStdArrays plugin instead
> that would control whether that plugin does callbacks to any downstream
> plugins subscribed to it. That would be an unusual thing to do, since normal
> the NDPluginStdArrays plugin is not connected to any downstream plugins.
I had both the NDPluginStdArrays and the camera with the same $(R). Changing that and following your instructions on which callbacks to enable made the acquisition successful.
Thank you,
Iain.
- References:
- EPICS PV for data in Area Detector Iain Marcuson
- RE: EPICS PV for data in Area Detector Mark Rivers
- RE: EPICS PV for data in Area Detector Iain Marcuson
- RE: EPICS PV for data in Area Detector Mark Rivers
- Navigate by Date:
- Prev:
Re: Archiver Appliance scripted alias record Shankar, Murali
- Next:
need to monitor the subArray record field NORD Lussignol Yves
- Index:
1994
1995
1996
1997
1998
1999
2000
2001
2002
2003
2004
2005
2006
2007
2008
2009
2010
2011
2012
2013
2014
2015
2016
<2017>
2018
2019
2020
2021
2022
2023
2024
- Navigate by Thread:
- Prev:
RE: EPICS PV for data in Area Detector Mark Rivers
- Next:
Question about build StreamDevice application lzf neu
- Index:
1994
1995
1996
1997
1998
1999
2000
2001
2002
2003
2004
2005
2006
2007
2008
2009
2010
2011
2012
2013
2014
2015
2016
<2017>
2018
2019
2020
2021
2022
2023
2024