Experimental Physics and Industrial Control System
StreamDevice provides ‘@init’ exception handlers for performing actions at IOC startup time. This works fine as long as the target device is up and running at that time. If the device is not readable at that time these exception handlers don’t have the desired effect. Would it be possible to provide a ‘@reconnect’ handler that would be invoked when the ASYN port made the transition from disconnected to connected?
I don’t think that this would allow initialization of output record values since AFAIK that’s possible only at record initialization time, but would at least allow for initialization command sequences to be sent to the device to get it into some desired operating mode.
--
Eric Norum
[email protected]
- Navigate by Date:
- Prev:
RE: AreaDetector / ADURL queries Mark Rivers
- Next:
StreamDevice exception handlers Eric Norum
- Index:
1994
1995
1996
1997
1998
1999
2000
2001
2002
2003
2004
2005
2006
2007
2008
2009
2010
2011
2012
2013
2014
2015
2016
<2017>
2018
2019
2020
2021
2022
2023
2024
- Navigate by Thread:
- Prev:
Re: new MVME5500, device "gei0" not found Dirk Zimoch
- Next:
StreamDevice exception handlers Eric Norum
- Index:
1994
1995
1996
1997
1998
1999
2000
2001
2002
2003
2004
2005
2006
2007
2008
2009
2010
2011
2012
2013
2014
2015
2016
<2017>
2018
2019
2020
2021
2022
2023
2024