Experimental Physics and Industrial Control System
Hi Vandana,
The mechanism in EPICS when an error like that occurs is not to clear the last stored value. Rather the mechanism is to put the record into an "alarm" state. caget should report the alarm state of the record, and you can display the alarm state on the standard EPICS GUI displays.
When the link is broken you can display the full state of the record with the following command at the iocsh shell.
dbpr "myRecord" 10
Please send the output of that command so we can see if the record is correctly being placed into an alarm state.
Mark
________________________________
From: [email protected] [[email protected]] on behalf of Vandana Yadav [[email protected]]
Sent: Monday, March 06, 2017 4:05 AM
To: [email protected]
Subject: Question related to PV record
Hi,
I am trying to communicate a device using RS-232 serial interface supported by EPICS. For that purpose, I have done the basic things such as creating IOC, installing StreamDevice and AsynDriver.
I am facing the problem that if the link is broken or not connected then the last stored values are being displayed in IOC by putting caget and caput commands. How can i resolve this ? Is there any procedure to clear the last stored value ?
Thanks in advance!
Regards,
Vandana
- Replies:
- Re: Question related to PV record Kasemir, Kay
- References:
- Question related to PV record Vandana Yadav
- Navigate by Date:
- Prev:
Question related to PV record Vandana Yadav
- Next:
Re: Question related to PV record Kasemir, Kay
- Index:
1994
1995
1996
1997
1998
1999
2000
2001
2002
2003
2004
2005
2006
2007
2008
2009
2010
2011
2012
2013
2014
2015
2016
<2017>
2018
2019
2020
2021
2022
2023
2024
- Navigate by Thread:
- Prev:
Question related to PV record Vandana Yadav
- Next:
Re: Question related to PV record Kasemir, Kay
- Index:
1994
1995
1996
1997
1998
1999
2000
2001
2002
2003
2004
2005
2006
2007
2008
2009
2010
2011
2012
2013
2014
2015
2016
<2017>
2018
2019
2020
2021
2022
2023
2024