EPICS Home

Experimental Physics and Industrial Control System


 
1994  1995  1996  1997  1998  1999  2000  2001  2002  2003  2004  2005  2006  2007  2008  2009  2010  2011  2012  2013  2014  2015  2016  <20172018  2019  2020  2021  2022  2023  2024  Index 1994  1995  1996  1997  1998  1999  2000  2001  2002  2003  2004  2005  2006  2007  2008  2009  2010  2011  2012  2013  2014  2015  2016  <20172018  2019  2020  2021  2022  2023  2024 
<== Date ==> <== Thread ==>

Subject: FEMTO amplifier DLPCA-200
From: Ibrahim Saleh <[email protected]>
To: "[email protected]" <[email protected]>
Date: Wed, 8 Feb 2017 11:57:22 +0000

Dear All,

 

I have a question regarding the FEMTO amplifier DLPCA-200.

What is the recommended I/O card to connect the amplifier to it? The EPICS support for DLPCA-200, which is inside “std-3-1”, will it support that hardware?

 

Best Regards,

 

Ibrahim Saleh

Control Engineer

SESAME

 


Replies:
RE: FEMTO amplifier DLPCA-200 Miceli, Antonino

Navigate by Date:
Prev: Re: How to support a new stepper motor controller? Rod Nussbaumer
Next: RE: FEMTO amplifier DLPCA-200 Miceli, Antonino
Index: 1994  1995  1996  1997  1998  1999  2000  2001  2002  2003  2004  2005  2006  2007  2008  2009  2010  2011  2012  2013  2014  2015  2016  <20172018  2019  2020  2021  2022  2023  2024 
Navigate by Thread:
Prev: RE: How to support a new stepper motor controller? Mark Rivers
Next: RE: FEMTO amplifier DLPCA-200 Miceli, Antonino
Index: 1994  1995  1996  1997  1998  1999  2000  2001  2002  2003  2004  2005  2006  2007  2008  2009  2010  2011  2012  2013  2014  2015  2016  <20172018  2019  2020  2021  2022  2023  2024