Experimental Physics and
Industrial Control System

hulusi <[email protected]> · Mon, 18 Jul 2016 11:26:18 +0300

Hi everyone,

I am new at EPICS. I am confused about using Visual DCT. I can easily

reading data and writing data from the terminal. However, i could not

make any condition loop inside the database and also could not

comminucate the ports or hardware that are already supported by EPICS.

If there any resources,tutorials or videos about this topic, i will be

really pleasure to know.Because, i could not find any detailed document

on the Internet.

Thanks in advance..
Best Regards..

Hulusi Öz
Mechatronic Engineer