Experimental Physics and
Industrial Control System

Gerrit Kühn <[email protected]> · Tue, 23 Feb 2016 16:24:07 +0100

On Tue, 23 Feb 2016 14:57:09 +0000 Mark Rivers <[email protected]>
wrote about RE: Motor examples missing devSequencer:

Hello Mark,

MR> If you are in that motor/iocBoot/iocWithAsyn directory you do the
MR> following:
MR> 
MR> ../../bin/linux-x86_64/WithAsyn st.cmd.AG_UC

Yes, that's what I did. After coming up with some envPaths settings it
appears to find everything it needs now and creates these channels for me:

iocRun: All initialization complete
epics> dbl
IOC:m1Direction
IOC:m2Direction
IOC:m1
IOC:m2
IOC:m1Offset
IOC:m1Resolution
IOC:m2Offset
IOC:m2Resolution
IOC:serial1

I have a UC8 controller here, so I probably can configure/address another
three sets of 2-axis controls in the .cmd file?

MR> You then need to load an OPI screen (there are lots of examples in the
MR> motor module) passing it the names of the motor records, and you
MR> should be able to move the motors.

We are using medm here, but I see that there are loads of .adl screens to look at, too. 

MR> Let me know if you have more questions.

I certainly will. :)
Thank you already for your support so far.

cu
  Gerrit

Experimental Physics and Industrial Control System

Experimental Physics and
Industrial Control System