On Tue, 23 Feb 2016 15:06:56 +0100 Benjamin Franksen
<[email protected]> wrote about Re: Motor examples
missing devSequencer:
Hello Ben,
BF> To answer your original question: Version 2.2 of the sequencer no
BF> longer has the devSequencer device support. You should be able to
BF> proceed with seq-2.2.3 by deleting the offending line from
BF> PI_GCS2Support.dbd . If the latter file is generated by make and not a
BF> source file, remove the line saying "DBD_whatever += devSequencer.dbd"
BF> from the Makefile. You probably also need to remove a line that says
BF> something like "xxx_LIBS += devSequencer" from the Makefile.
I was able to compile everything cleanly with the new sequencer using the
development version of the motor record as suggested by Mark.
Now I just need to understand how to use all this for the AG_UC motor
hardware I have here. I found an example st.cmd.AG_UC that finds the
controller and creates some channels... what part of the documentation is
the next suggested read?
cu
Gerrit
- Replies:
- RE: Motor examples missing devSequencer Mark Rivers
- References:
- Motor examples missing devSequencer Gerrit Kühn
- Re: Motor examples missing devSequencer Benjamin Franksen
- Navigate by Date:
- Prev:
Re: How to cs-studio Scan System Kasemir, Kay
- Next:
RE: Motor examples missing devSequencer Mark Rivers
- Index:
1994
1995
1996
1997
1998
1999
2000
2001
2002
2003
2004
2005
2006
2007
2008
2009
2010
2011
2012
2013
2014
2015
<2016>
2017
2018
2019
2020
2021
2022
2023
2024
- Navigate by Thread:
- Prev:
Re: Motor examples missing devSequencer Benjamin Franksen
- Next:
RE: Motor examples missing devSequencer Mark Rivers
- Index:
1994
1995
1996
1997
1998
1999
2000
2001
2002
2003
2004
2005
2006
2007
2008
2009
2010
2011
2012
2013
2014
2015
<2016>
2017
2018
2019
2020
2021
2022
2023
2024
|