Experimental Physics and
Industrial Control System

1994 1995 1996 1997 1998 1999 2000 2001 2002 2003 2004 2005 2006 2007 2008 2009 2010 2011 2012 2013 2014 2015 <2016> 2017 2018 2019 2020 2021 2022 2023 2024	Index	1994 1995 1996 1997 1998 1999 2000 2001 2002 2003 2004 2005 2006 2007 2008 2009 2010 2011 2012 2013 2014 2015 <2016> 2017 2018 2019 2020 2021 2022 2023 2024
<== Date ==>		<== Thread ==>

Subject:	RE: Danfysik 8500 or 9100 power supply driver
From:	<[email protected]>
To:	<[email protected]>
Date:	Fri, 29 Jan 2016 10:48:28 +0000

We have a stream device application for the MPS8000 that has been in use at the MICE project for several years.

Pete

From: [email protected] [mailto:[email protected]] On Behalf Of Schrock, Ken
Sent: 28 January 2016 19:41
To: [email protected]
Cc: Holland, Kent
Subject: Danfysik 8500 or 9100 power supply driver

Hello,

We are purchasing several Danfysik model 9100 power supplies for FRIB at MSU. Before developing a new EPICS driver, we are curious if any users already have one for either the 8500 or 9100? Danfysik told us that the command set is the same for both models.

Regards,

Ken Schrock

Electrical Staff Engineer

Facility for Rare Isotope Beams

Michigan State University

640 South Shaw Lane

East Lansing, MI 48824, USA

Tel. 517-908-7193

Email: [email protected]