Experimental Physics and
Industrial Control System

Jack <[email protected]> · Fri, 29 Jan 2016 09:49:59 +0100

Hi Ken,

we have modified the original driver of Danfisyc 8000 power supply, we

can share the work.

Thanks,
-Mauro

On 1/28/2016 9:57 PM, Lewis, Wayne wrote:

Hi Ken,

We have EPICS support for the Danfysik 892 power supplies here at
NSLS-II. If that's also the same command set, I can send you the
details.

Wayne

On Thu, Jan 28, 2016 at 07:41:08PM +0000, Schrock, Ken wrote:

Hello,

We are purchasing several Danfysik model 9100 power supplies for FRIB at MSU.  Before developing a new EPICS driver, we are curious if any users already have one for either the 8500 or 9100?  Danfysik told us that the command set is the same for both models.

Regards,

Ken Schrock
Electrical Staff Engineer
Facility for Rare Isotope Beams
Michigan State University
640 South Shaw Lane
East Lansing, MI 48824, USA
Tel. 517-908-7193
Email: [email protected]<mailto:[email protected]>

[cid:[email protected]]

--
________________________________________________________________________

Mauro Giacchini

Control Systems Specialist
INFN Laboratori Nazionali di Legnaro
Viale Università 2
I 35020 Legnaro (Padova)
Tel. +39 049 8068 558
Fax               558

EPICS _at_ LNL http://www.lnl.infn.it/~epics/

...the first EPICS installation to the project SPES realized from the
scratch in ITALY is in production since begin 2010!!
________________________________________________________________________

---
This email has been checked for viruses by Avast antivirus software.
https://www.avast.com/antivirus

Experimental Physics and Industrial Control System

Experimental Physics and
Industrial Control System