Experimental Physics and
Industrial Control System

Hi Ken,

We have EPICS support for the Danfysik 892 power supplies here at
NSLS-II. If that's also the same command set, I can send you the
details.

Wayne

On Thu, Jan 28, 2016 at 07:41:08PM +0000, Schrock, Ken wrote:
> Hello,
> 
> We are purchasing several Danfysik model 9100 power supplies for FRIB at MSU.  Before developing a new EPICS driver, we are curious if any users already have one for either the 8500 or 9100?  Danfysik told us that the command set is the same for both models.
> 
> Regards,
> 
> Ken Schrock
> Electrical Staff Engineer
> Facility for Rare Isotope Beams
> Michigan State University
> 640 South Shaw Lane
> East Lansing, MI 48824, USA
> Tel. 517-908-7193
> Email: [email protected]<mailto:[email protected]>
> 
> [cid:[email protected]]
> 
> 
> 
> 
> 
> 
> 



-- 
Wayne Lewis
NSLS-II Controls Group
Brookhaven National Laboratory
(p) +1 (631) 344 5936
(f) +1 (631) 344 8085
(e) [email protected]
(w) www.bnl.gov/nsls2

Replies:

Re: Danfysik 8500 or 9100 power supply driver Jack

References:

Danfysik 8500 or 9100 power supply driver Schrock, Ken

Navigate by Date:

Prev: Danfysik 8500 or 9100 power supply driver Schrock, Ken

Next: devlib2 2.7 release Michael Davidsaver

Index: 1994  1995  1996  1997  1998  1999  2000  2001  2002  2003  2004  2005  2006  2007  2008  2009  2010  2011  2012  2013  2014  2015  <2016>  2017  2018  2019  2020  2021  2022  2023  2024 

Navigate by Thread:

Prev: Danfysik 8500 or 9100 power supply driver Schrock, Ken

Next: Re: Danfysik 8500 or 9100 power supply driver Jack

Index: 1994  1995  1996  1997  1998  1999  2000  2001  2002  2003  2004  2005  2006  2007  2008  2009  2010  2011  2012  2013  2014  2015  <2016>  2017  2018  2019  2020  2021  2022  2023  2024