Experimental Physics and
Industrial Control System

I am studying the use of an EPICS IOC in a redundant configuration. As far as I can see the most recent version (3.15.3) does not include the necessary RMTLIB en CCELIB. Is redundancy supported yet or are there any plans in that direction?

 

 

---

P Denk aan het milieu - dit mailtje printen is niet altijd nodig | Please consider the environment - before printing this email

---

ATTENTION:

The information in this email message is private and
confidential, and only intended for the addressee. Should you
receive this message by mistake, you are hereby notified that
any disclosure, reproduction, distribution or use of this
message is strictly prohibited. Please inform the sender by
reply transmission and delete the message without reading it.

For further information you can reach the sender either by email or
by regular mail on the following address:

Eekels Technology B.V.
A. Plesmanlaan 2
9615 TH Kolham
The Netherlands

-- 
------------------------------------------------------------------------
Matthias Clausen                         Cryogenic Controls Group(MKS-2)
phone:  +49-40-8998-3256                Deutsches Elektronen Synchrotron
fax:    +49-40-8994-3256                                    Notkestr. 85
e-mail: [email protected]                           22607 Hamburg
WWW-MKS2.desy.de                                                 Germany
------------------------------------------------------------------------