Experimental Physics and
Industrial Control System

Does setting the SmartStageName to an empty string prevent the XPS's
"Auto configuration" from auto-detecting which axis is connected to a
channel?

Do you configure your XPS controllers manually?

Kevin

On 7/12/15 4:51 PM, Mark Rivers wrote:
> Note that I have commented out the line 
> 
> ;SmartStageName = UTS100CC
> 
> and replaced it with:
> 
> SmartStageName = 

Replies:

RE: Stepper Motor Controllers Mark Rivers

References:

Stepper Motor Controllers Mark Davis

Re: Stepper Motor Controllers Mark Rivers

Re: Stepper Motor Controllers Kevin Peterson

Re: Stepper Motor Controllers Mark Rivers

RE: Stepper Motor Controllers Mark Rivers

Navigate by Date:

Prev: StripTool Current Value Following IOC Reboot Poff, Mark A

Next: RE: Stepper Motor Controllers Mark Rivers

Index: 1994  1995  1996  1997  1998  1999  2000  2001  2002  2003  2004  2005  2006  2007  2008  2009  2010  2011  2012  2013  2014  <2015>  2016  2017  2018  2019  2020  2021  2022  2023  2024 

Navigate by Thread:

Prev: RE: Stepper Motor Controllers Mark Rivers

Next: RE: Stepper Motor Controllers Mark Rivers

Index: 1994  1995  1996  1997  1998  1999  2000  2001  2002  2003  2004  2005  2006  2007  2008  2009  2010  2011  2012  2013  2014  <2015>  2016  2017  2018  2019  2020  2021  2022  2023  2024