Experimental Physics and
Industrial Control System

Kevin Peterson <[email protected]> · Fri, 10 Jul 2015 15:10:23 -0500

One disadvantage of the Newport XPS controller is that the controller
requires its configuration to match the stages that are physically
connected.  If one stage is disconnected from the controller, none of
the other axes will be usable until the unused axis is reconfigured to
be a dummy axis.  For stable setups this isn't an issue.  For
frequently-changing setups this can be quite annoying.

Kevin

On 7/10/15 9:58 AM, Mark Rivers wrote:
> We have 11 Newport XPS controllers on our beam lines. In my
> experience they are much easier to configure than the Delta Tau
> units. They have a user-friendly Web interface, all parameters are in
> engineering units, etc. There is an EPICS interface to complex
> multi-axis coordinated motion with detector triggering, and lots of
> other auxiliary I/O.
> 
> Mark
> 

Experimental Physics and Industrial Control System

Experimental Physics and
Industrial Control System