Good afternoon,
I was hoping to use EPICS to control motors through a Newport XPS-C and receive data from an Andor Zyla detector. I have Windows 7 installed with EPICS 3.14.12.4 and synApps 5.7 (motor6-8) but I have been unable to figure out how to connect to my XPS. I have modified st.cmd.xps but haven't been able to connect and control the motors. Is there some sort of tutorial that I have missed online that would be helpful? Right now I'm just looking to connect and maybe move an XYZ stage before moving onto the more complicated trajectory scans that I see tutorials for online.
Thank you,
Andy
- Replies:
- RE: Setting up Newport XPS-C on Windows 7 Mark Rivers
- Navigate by Date:
- Prev:
Re: MEDM issues Jennings, Guy
- Next:
RE: Setting up Newport XPS-C on Windows 7 Mark Rivers
- Index:
1994
1995
1996
1997
1998
1999
2000
2001
2002
2003
2004
2005
2006
2007
2008
2009
2010
2011
2012
2013
2014
<2015>
2016
2017
2018
2019
2020
2021
2022
2023
2024
- Navigate by Thread:
- Prev:
RE: caQtDM evaluation at SLAC Mezger Anton Christian (PSI)
- Next:
RE: Setting up Newport XPS-C on Windows 7 Mark Rivers
- Index:
1994
1995
1996
1997
1998
1999
2000
2001
2002
2003
2004
2005
2006
2007
2008
2009
2010
2011
2012
2013
2014
<2015>
2016
2017
2018
2019
2020
2021
2022
2023
2024
|