Experimental Physics and
Industrial Control System

So…

 

I think I may have run into a problem, that I can’t figure….

 

I’m creating 2 .db files using substitution files and 4-template files (ai,ao,bi,bo,…).

 

In the Makefile, I have these lines (different because I was trying to diagnose what’s going on):

 

When I change the first template file template file, both output files generate fine.

When I change any of the other template files, only the second output file generates.

 

I originally had all the templates on a single line, as in the second file definition, but that didn’t work either.

 

Looking at the definition in 4.6.10, it seems that perhaps I shouldn’t be able to define more than one template file anyway????

 

Ideas would be appreciated.

 

Later-

 

David Dudley Controls Engineer III Facility for Rare Isotope Beams Michigan State University 640 South Shaw Lane East Lansing, MI 48824, USA Tel. 517-908-7133 Email: [email protected]