Experimental Physics and
Industrial Control System

Hi,

We plan to use a soft IOC and an OMS MAXnet motion controller to control a stepper motor.  The soft IOC will communicate with the MAXnet motion controller's Ethernet interface.  What are the existing EPICS device/driver supports that we can use for this soft IOC application?  Can APS's Stepper/DC Motor Controller software or Mark Rivers' devMotorAsyn and drvMotorAsyn be used for this?  What are the pros and cons comparing these two technologies?  Are there other alternatives?

Advice is greatly appreciated.  Thank you in advance.

William Lu

Replies:

Re: Device/Driver Support for Stepper Motor Control Ron Sluiter

Navigate by Date:

Prev: Re: Trouble with OID name using devsnmp. John A. Priller

Next: Re: Device/Driver Support for Stepper Motor Control Ron Sluiter

Index: 1994  1995  1996  1997  1998  1999  2000  2001  2002  2003  2004  2005  2006  2007  2008  2009  2010  2011  2012  2013  <2014>  2015  2016  2017  2018  2019  2020  2021  2022  2023  2024 

Navigate by Thread:

Prev: Re: Trouble with OID name using devsnmp. Nicoletta Petrella

Next: Re: Device/Driver Support for Stepper Motor Control Ron Sluiter

Index: 1994  1995  1996  1997  1998  1999  2000  2001  2002  2003  2004  2005  2006  2007  2008  2009  2010  2011  2012  2013  <2014>  2015  2016  2017  2018  2019  2020  2021  2022  2023  2024