Dear all,
this little survey is based on this:
The conventional input devices, like mouse or keyboard, are not suitable
to fine-tuning operation.
The operators has requested a set of control knobs to this task,
Please, Would you tell me how is handled at different EPICS sites ?
...hardware, software, interfaces (Ethernet ..?)
This would be installed on a new control system, therefore I'm looking
to an updated solution with a minimum effort to maintenance in the
future, but strongly reliable to be in production on an operator console.
Thank you very much to your collaboration in advance,
-Mauro
--
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
Mauro Giacchini
Istituto Nazionale di Fisica Nucleare - Laboratori Nazionali di Legnaro
V.le dell'Universita', 2
35020 LEGNARO (PD) - ITALY
Tel./Fax. +39.049.8068558
EPICS _at_ LNL http://www.lnl.infn.it/~epics/
...the first EPICS installation to the project SPES realized from the
scratch in ITALY is in production since begin 2010!!
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
- Replies:
- Re: control knobs to a new control system Rob Emery
- RE: control knobs to a new control system Emmanuel Mayssat
- Navigate by Date:
- Prev:
Vme support in devLib for Linux Jane Richards
- Next:
Re: control knobs to a new control system Rob Emery
- Index:
1994
1995
1996
1997
1998
1999
2000
2001
2002
2003
2004
2005
2006
2007
2008
2009
2010
2011
2012
2013
<2014>
2015
2016
2017
2018
2019
2020
2021
2022
2023
2024
- Navigate by Thread:
- Prev:
Re: Vme support in devLib for Linux Dirk Zimoch
- Next:
Re: control knobs to a new control system Rob Emery
- Index:
1994
1995
1996
1997
1998
1999
2000
2001
2002
2003
2004
2005
2006
2007
2008
2009
2010
2011
2012
2013
<2014>
2015
2016
2017
2018
2019
2020
2021
2022
2023
2024
|