Hi, there,
We have Delta Tau PMAC VME Motion Controller. When I replaced some of
our malfunction PMAC VME cards, I have a base address issue.
I did the following commands to set up replacement PMAC's VME base
address and communication. The designated base address is 0x807FA200 and
DPRAM address is 0x80704000.
WX$0783,$09,$04,$80,$7F,$A2,$02,$A5,$70,$E0,$80
SAVE
$$$
Then I restored configuration file to PMAC's VME and rebooted its IOC.
The error message is below.
pmacVmeConfig (1, 0x807FA200, 0x80704000, 0xa5, 2)
pmacVmeConfig: Failure probing for base address. value = -1 = 0xffffffff
= _clientQ + 0xff051efb
Could someone help me?
Thank you,
Chen
- Replies:
- RE: PMAC VME card base address issue Emma Shepherd
- Navigate by Date:
- Prev:
RE: assign subArray record value Mooney, Tim M.
- Next:
seq and synchronous writes Konrad, Martin
- Index:
1994
1995
1996
1997
1998
1999
2000
2001
2002
2003
2004
2005
2006
2007
2008
2009
2010
2011
2012
<2013>
2014
2015
2016
2017
2018
2019
2020
2021
2022
2023
2024
- Navigate by Thread:
- Prev:
RE: No reply from device within 1000 ms Mooney, Tim M.
- Next:
RE: PMAC VME card base address issue Emma Shepherd
- Index:
1994
1995
1996
1997
1998
1999
2000
2001
2002
2003
2004
2005
2006
2007
2008
2009
2010
2011
2012
<2013>
2014
2015
2016
2017
2018
2019
2020
2021
2022
2023
2024
|