in my little sequencer program I defined
double RUN;
assign RUN to "{DEVICE}:ENA_CMD";
monitor RUN;
were "{DEVICE}:ENA_CMD"; is a bo record which is set to "1" and kept
that way even if the iocapp restarts with autosave
but during the iocstartup after the iocinit all is fine (bo still
enabled ("1")) 'til the sequencer routine starts then it goes to
disabled "0".
Is there any chance to keep the PV values as it was during the seq-init?
thanks for the help
- Replies:
- Re: SEQ keep PV value during seq-init Benjamin Franksen
- Navigate by Date:
- Prev:
Re: pvGet timeout in sequencer 2.1.12 Benjamin Franksen
- Next:
Re: pvGet timeout in sequencer 2.1.12 J. Lewis Muir
- Index:
1994
1995
1996
1997
1998
1999
2000
2001
2002
2003
2004
2005
2006
2007
2008
2009
2010
2011
2012
<2013>
2014
2015
2016
2017
2018
2019
2020
2021
2022
2023
2024
- Navigate by Thread:
- Prev:
CSS plugin sources James F Ross
- Next:
Re: SEQ keep PV value during seq-init Benjamin Franksen
- Index:
1994
1995
1996
1997
1998
1999
2000
2001
2002
2003
2004
2005
2006
2007
2008
2009
2010
2011
2012
<2013>
2014
2015
2016
2017
2018
2019
2020
2021
2022
2023
2024
|