Experimental Physics and
Industrial Control System

Hi Hinko,

I would do this with a seq record.

Tim

----- Original Message -----
> From: "Hinko Kočevar" <[email protected]>
> To: [email protected]
> Sent: Friday, June 7, 2013 1:56:12 AM
> Subject: Changing SCAN field in many records
> 
> Hi,
> 
> We would like to set a SCAN field on several lower level BO records,
> at
> the same time, and the value of these SCAN fields should reflect the
> value of the single higher level record SCAN field.
> 
> For the control of these lower level SCAN fields another, higher
> level
> record, would be used. If a user wishes to set individual lower level
> record SCAN fields, she is allowed. OTOH, when changing the SCAN of
> the
> higher level record, ALL lower lever BO records would get their SCAN
> field set too.
> 
> Is it possible to get this done without using a sequencer?
> 
> TIA and HAND,
> Hinko
> 

Replies:

Re: Changing SCAN field in many records Hinko Kočevar

References:

Changing SCAN field in many records Hinko Kočevar

Navigate by Date:

Prev: Re: Changing SCAN field in many records Ralph Lange

Next: RE: IP330 modules question Mark Rivers

Index: 1994  1995  1996  1997  1998  1999  2000  2001  2002  2003  2004  2005  2006  2007  2008  2009  2010  2011  2012  <2013>  2014  2015  2016  2017  2018  2019  2020  2021  2022  2023  2024 

Navigate by Thread:

Prev: Re: Changing SCAN field in many records Fabian S.

Next: Re: Changing SCAN field in many records Hinko Kočevar

Index: 1994  1995  1996  1997  1998  1999  2000  2001  2002  2003  2004  2005  2006  2007  2008  2009  2010  2011  2012  <2013>  2014  2015  2016  2017  2018  2019  2020  2021  2022  2023  2024