Experimental Physics and
Industrial Control System

Martin Konrad <[email protected]> · Fri, 20 Jul 2012 15:43:53 +0200

Hi,
what's the recommended way to switch from one sequencer state to another
if a button is clicked on the OPI? What type of record do you use for
this? What does the "when" statement look like?

Thanks in advance

Martin

P.S.: When coupling a button with some piece of hardware I usually use
some sort of record that is scanned if the button is clicked. This
results in a message to my device. This obviously does not work with the
sequencer because the value of the record does not change and thus a
monitor would not fire...

-- 
Dipl. Phys. Martin Konrad
Technische Universität Darmstadt
Institut für Kernphysik
Schlossgartenstr. 9
64289 Darmstadt
Tel.: +49-6151-16-5121
Fax: +49-6151-16-4321

Experimental Physics and Industrial Control System

Experimental Physics and
Industrial Control System