Experimental Physics and
Industrial Control System

"GOURNAY Jean-Francois" <[email protected]> · Fri, 16 Mar 2012 15:30:57 +0000

My answer was a little bit misleading (euphemism !)
The correct one is:

VxWorks version 5.3.1
KERNEL: WIND version 2.5

Thanks to Pierre Mattei to have pointed out this error.

-----Message d'origine-----
De : Bill Lavender [mailto:[email protected]] 
Envoyé : mercredi 14 mars 2012 03:27
À : GOURNAY Jean-Francois; [email protected]
Objet : Re: MVME2434-1

I had been hoping for VxWorks 5 code, so VxWorks 2.5 is rather old.
However, I see that RTEMS has a BSP for the MVME2400 series.  Do you think that I would be better off with RTEMS and just forgetting about VxWorks?

Bill Lavender

On Tue, Mar 13, 2012 at 01:25:51PM +0000, GOURNAY  Jean-Francois wrote:
> Yes we use this CPU in several configuration for Acquisition systems for Magnet Protection system here at Saclay (W7X stellerator magnets  and R3B GSI magnet), at CERN (COMPASS solenoid) and Tokaï (T2K  J-PARC).
> The oldest configuration is more than 10 y.o. We never had any problem with this CPU. Quite different from the present situation where we had a lot of problem with our  present 5500 CPU choice.
> We are running an old configuration on them: VxWorks 2.5 buit in 2000 
> and EPICS 3.13
> 
> Jean-François
> 
> -----Message d'origine-----
> De : [email protected] 
> [mailto:[email protected]] De la part de Bill Lavender 
> Envoyé : lundi 12 mars 2012 22:33 À : [email protected] Objet : 
> MVME2434-1
> 
> I have recently acquired an MVME2434-1 system controller board.  Is this something that anyone has ever used with EPICS?  Thanks.
> 
> Bill Lavender
> 

Experimental Physics and Industrial Control System

Experimental Physics and
Industrial Control System