Hello all,
I’ve just installed EPICS base (3.14.12.1) on Windows
XP with Cygwin (EPICS_HOST_ARCH = cygwin-x86). To verify the
installation, I was attempting to building the Example IOC application (per
Section 2.2 of the Application Developer’s Guide).
Unfortunately, I am encountering the following errors upon
attempting to compile:
$ make
make -C ./configure
install
make[1]: Entering
directory `/cygdrive/c/mytop/configure'
make -C O.cygwin-x86
-f ../Makefile TOP=../.. T_A=cygwin-x86 install
make[2]: Entering
directory `/cygdrive/c/mytop/configure/O.cygwin-x86'
perl
c:/EPICS/base/bin/cygwin-x86/convertRelease.pl checkRelease
make[2]: Leaving
directory `/cygdrive/c/mytop/configure/O.cygwin-x86'
make[1]: Leaving
directory `/cygdrive/c/mytop/configure'
make -C
./myexampleApp install
make[1]: Entering
directory `/cygdrive/c/mytop/myexampleApp'
make -C ./src
install
make[2]: Entering
directory `/cygdrive/c/mytop/myexampleApp/src'
make -C O.cygwin-x86
-f ../Makefile TOP=../../.. T_A=cygwin-x86 install
make[3]: Entering
directory `/cygdrive/c/mytop/myexampleApp/src/O.cygwin-x86'
c:/EPICS/base/configure/RULES_TARGET:69:
*** multiple target patterns. Stop.
make[3]: Leaving
directory `/cygdrive/c/mytop/myexampleApp/src/O.cygwin-x86'
make[2]: ***
[install.cygwin-x86] Error 2
make[2]: Leaving
directory `/cygdrive/c/mytop/myexampleApp/src'
make[1]: ***
[src.install] Error 2
make[1]: Leaving
directory `/cygdrive/c/mytop/myexampleApp'
make: ***
[myexampleApp.install] Error 2
Not sure if this is an indication that I have a bad EPICS
base build and/or have something lacking in my environment, etc. Any
help/info/assistance will be greatly appreciated.
Thanks in advance,
Florencio
Cid