Hello.
I am looking for an EPICS compatible hardware switch that has two enumerated
PV values. For example when the switch is pressed its PV value is 1 and when
the switch is released its PV value is 0. I need to run that on a software IOC
Linux box. I have Keythley multimeter and I could use one of its channels for
that purpose but maybe someone else has already done something similar or
there is an existing hardware solution that can run on soft IOC ?
Thank you.
--
Miroslav Mihaylov
University of Illinois at Chicago
Department of Physics
2336 SES
845 W. Taylor St. M/C 273
Chicago, IL 60607
312 355 0225
- Replies:
- Re: EPICS Soft IOC hardware switch Eric Norum
- Navigate by Date:
- Prev:
RE: SNL seq-2.0.13 on Linux 64 bits: not all monitored PVs receive their first monitor event Gurd Pamela EXT
- Next:
Re: Does EPICS Base support multi-thread on vxWorks 6.3? Andrew Johnson
- Index:
1994
1995
1996
1997
1998
1999
2000
2001
2002
2003
2004
2005
2006
2007
2008
2009
2010
<2011>
2012
2013
2014
2015
2016
2017
2018
2019
2020
2021
2022
2023
2024
- Navigate by Thread:
- Prev:
RE: SNL seq-2.0.13 on Linux 64 bits: not all monitored PVs receive their first monitor event Utzel Nadine
- Next:
Re: EPICS Soft IOC hardware switch Eric Norum
- Index:
1994
1995
1996
1997
1998
1999
2000
2001
2002
2003
2004
2005
2006
2007
2008
2009
2010
<2011>
2012
2013
2014
2015
2016
2017
2018
2019
2020
2021
2022
2023
2024
|