Experimental Physics and
Industrial Control System

Eric Norum <[email protected]> · Thu, 16 Jun 2011 11:08:15 -0700

The example IOC template includes a sequencer program.  I suggest that you use that as a starting point:

makeBaseApp -t example example
makeBaseApp -t example -i example

then edit configure/RELEASE and set SNCEQ 
then 'make' and you should have a runnable IOC with an operational sequencer.

On Jun 16, 2011, at 10:47 AM, Bradley Pietrzak wrote:

> Hello,
> 
> I am a student working at the Indiana Univeristy Center for the Exploration of Energy and Matter.  Recently, a collegue and I have been tasked with using the EPICS sequencer to cycle some magnets.  However, neither of us are at all familiar with using state notation language.  Our setup is this: we have a computer with a virtual machine on it that contains EPICS and the sequencer.  We do all of our work from a different machine that runs Red Hat Linux.  Using that machine, we ssh into the EPICS virtual machine.  While I have read a couple State Notation Language tutorials, I am still unclear on some key concepts.  What I would most like to know is how to start from nothing and make a program that does nothing more than print the text "Hello World".  I think what confuses us most is how to go from a file named "HelloWorld.st" to something we can actually execute.  At least for now, lets assume that all of the relevant compilers are successfully installed on the EPICS virtua!
 l machine.
> 
> Sincerely,
> 
> Brad Pietrzak

-- 
Eric Norum
[email protected]

Experimental Physics and Industrial Control System

Experimental Physics and
Industrial Control System