Hi Kristi,
On Wednesday 19 January 2011 15:27:24 Luchini, Kristi L. wrote:
>
> I can do dbpf() from the console port to change a DOL field, so is there a
> reason why dbPutLink can't or am I just using this incorrectly? Any
> suggestions?
You can't change a link field using a database link (I'm not quite sure why we
don't allow that but it's probably because of the locking needed), but you can
do it with a CA link, so try adding the CA flag to your genSub OUTx field.
Note that changing links is not a fast operation though, in some cases putting
a selRecord in front of your DOL link instead might make more sense.
- Andrew
--
If a man is offered a fact which goes against his instincts, he will
scrutinize it closely, and unless the evidence is overwhelming, he will
refuse to believe it. If, on the other hand, he is offered something
which affords a reason for acting in accordance to his instincts, he
will accept it even on the slightest evidence. -- Bertrand Russell
- Replies:
- RE: Changing DOL field from a subroutine record Luchini, Kristi L.
- References:
- Changing DOL field from a subroutine record Luchini, Kristi L.
- Navigate by Date:
- Prev:
RE: Problem exiting IOC Vigder, Mark
- Next:
RE: Changing DOL field from a subroutine record Luchini, Kristi L.
- Index:
1994
1995
1996
1997
1998
1999
2000
2001
2002
2003
2004
2005
2006
2007
2008
2009
2010
<2011>
2012
2013
2014
2015
2016
2017
2018
2019
2020
2021
2022
2023
2024
- Navigate by Thread:
- Prev:
Changing DOL field from a subroutine record Luchini, Kristi L.
- Next:
RE: Changing DOL field from a subroutine record Luchini, Kristi L.
- Index:
1994
1995
1996
1997
1998
1999
2000
2001
2002
2003
2004
2005
2006
2007
2008
2009
2010
<2011>
2012
2013
2014
2015
2016
2017
2018
2019
2020
2021
2022
2023
2024
|