Experimental Physics and
Industrial Control System

On 18.11.2010 09:32, Burkhard Kolb wrote:

Hi Ralph,
yes, I tried that. It exits only the thread. Same happens also when I try "exit"
on the iocsh. If I do a ^X in procServ, it kills it immediately - fine.
But I wanted to automate this.
Burkhard

Hi Burkhard,

In that case,

signal(getpid(), 9)

Sorry.
Ralph

Replies:

Re: How to shutdown/restart a soft-ioc from a (watchdog) record Burkhard Kolb

References:

How to shutdown/restart a soft-ioc from a (watchdog) record Burkhard Kolb

Re: How to shutdown/restart a soft-ioc from a (watchdog) record Andrew Johnson

Re: How to shutdown/restart a soft-ioc from a (watchdog) record Burkhard Kolb

Re: How to shutdown/restart a soft-ioc from a (watchdog) record Ralph Lange

Re: How to shutdown/restart a soft-ioc from a (watchdog) record Burkhard Kolb

Re: How to shutdown/restart a soft-ioc from a (watchdog) record Ralph Lange

Navigate by Date:

Prev: Re: How to shutdown/restart a soft-ioc from a (watchdog) record Ralph Lange

Next: Re: How to shutdown/restart a soft-ioc from a (watchdog) record Burkhard Kolb

Index: 1994  1995  1996  1997  1998  1999  2000  2001  2002  2003  2004  2005  2006  2007  2008  2009  <2010>  2011  2012  2013  2014  2015  2016  2017  2018  2019  2020  2021  2022  2023  2024 

Navigate by Thread:

Prev: Re: How to shutdown/restart a soft-ioc from a (watchdog) record Ralph Lange

Next: Re: How to shutdown/restart a soft-ioc from a (watchdog) record Burkhard Kolb

Index: 1994  1995  1996  1997  1998  1999  2000  2001  2002  2003  2004  2005  2006  2007  2008  2009  <2010>  2011  2012  2013  2014  2015  2016  2017  2018  2019  2020  2021  2022  2023  2024