Ron,
Phil Brown's letter implies that there is a range of boards affected,
because the problem started when "a change in a component by the
manufacturer ... worked into our supply". So there is a lower limit
to the serial numbers, below which we don't need to worry about
the problem. Does OMS know, in terms of serial numbers, about
where the problem crept in? I don't want to send back any boards
unnecessarily.
Thanks,
Kurt
On 10/27/2010 3:00 PM, Ron Sluiter wrote:
With their permission, I am passing along an announcement
from OMS concerning the reliability of their MAXv motor controller.
The short synopsis is; there was a problem, they have diagnosed it,
all boards after s/n 966 are fixed and they are offering to fix any
boards
before s/n 967 for free.
Ron
- Replies:
- Re: OMS MAXv announces fix Ron Sluiter
- Re: OMS MAXv announces fix Dirk Zimoch
- References:
- OMS MAXv announces fix Ron Sluiter
- Navigate by Date:
- Prev:
Re: EPICS on ARM (continued) Rod Nussbaumer
- Next:
Re: Some Channel Access Questions Ben Franksen
- Index:
1994
1995
1996
1997
1998
1999
2000
2001
2002
2003
2004
2005
2006
2007
2008
2009
<2010>
2011
2012
2013
2014
2015
2016
2017
2018
2019
2020
2021
2022
2023
2024
- Navigate by Thread:
- Prev:
OMS MAXv announces fix Ron Sluiter
- Next:
Re: OMS MAXv announces fix Ron Sluiter
- Index:
1994
1995
1996
1997
1998
1999
2000
2001
2002
2003
2004
2005
2006
2007
2008
2009
<2010>
2011
2012
2013
2014
2015
2016
2017
2018
2019
2020
2021
2022
2023
2024
|