Experimental Physics and
Industrial Control System

"zhuangjian" <[email protected]> · Fri, 22 Oct 2010 08:37:02 +0800

Hello, 

I think vxWorks 5.5.1 do not support ppc85xx cpu family. You need some patch from Windriver such as 
tor221_cds85xx_1_2_0,cum.tor2_2-e500.20070501,spr99776,spr100706,spr105250 .

------------------				 
ZHUANG, Jian(庄建)                                                           

DAQ group
Key Laboratory for Technologies of Nuclear Detection and Electronics
Expermental Physics Center
Institute of High Energy Physics
Chinese Academy of Sciences
19B YuquanLu, Shijingshan District, Beijing, 100049

E-mail:[email protected]
TEL:+86-10-88236172
2010-10-22

-------------------------------------------------------------
发件人：王林
发送日期：2010-10-21 23:47:13
收件人：[email protected]
抄送：
主题：cross-gcc-2.9.6 problem

Hello,
I want to ask a question about the cross-gcc-2.9.6.tar.gz provided by the SNS website http://ics-web.sns.ornl.gov/dht/ .
My task is to port CSNS RCS LLRF system to EPICS,my EPICS environment is as follows:
EPICS version    3.14.8.2
vxWorks version  5.5.1
cross compiler   crossgcc2.9.6
host             RHEL4.0
target           cPCI6200 board (have been chosen,but not purchased yet)
The problem is that the crossgcc2.9.6 supports ppc403,ppc405,ppc440,ppc603,ppc604 and ppc860 CPU families,but the CPU board cPCI6200 is based on the CPU MPC8572,which belongs to ppc85xx CPU family,thus the EPICS IOC compiled by crossgcc2.9.6 can not run on cPCI6200.
Is there any way to make the crossgcc2.9.6 support ppc85xx ?

Thanks

Experimental Physics and Industrial Control System

Experimental Physics and
Industrial Control System